Using the MIPRO PA System

Summary:

This article will walk you through the process of using the MIPRO PA System in a classroom.

Content:

System Components

The MIPRO PA System consists of the PA System Speaker, Power Cord, and Wireless Headset Microphone with Body Pack.


How to Request a MIPRO PA System for your classroom

A request should be submitted to the Instructional Continuity webform with your contact and room information.
 

Cleaning Instructions at the Start of Class

Before using the MIPRO PA System, you should use a regular disinfectant wipe and clean the wireless headset microphone and body pack. The entire device is safe for disinfectant wipe use.


Powering on the MIPRO PA System Speaker

Powering on and adjusting the volume requires adjustment of the first two dials on the rear of the speaker.

  1. Dial 1: Power & Mic Volume
    • To power on the speaker, locate the power & mic volume dial on the rear of the speaker. Turn the dial clockwise and set it to 1/2 the way from its start position.
    • This dial is used to control the overall volume and used to power off the speaker.
  2. Dial 2: CH1 Volume
    • This dial is used to adjust the microphone level. Turn the dial clockwise and set it to 1/2 the way from its start position. Test the microphone and raise slowly if adjustment is needed.

  


Powering on the MIPRO Wireless Headset Microphone

To power on the wireless headset, press the ON button on the body pack. The headset and speaker have been paired and should immediately connect for use.
Note: the body pack is powered by two AA batteries. If you need new batteries call the AV Services Hotline at 603-862-2467.

 

 

Wearing the MIPRO Wireless Headset

The headset is worn by placing the hooks over your ears facing forward. See the image below for the correct way to wear them.

Post-Class Instructions

  1. Power down the headset by pressing and holding the ON button on the body pack to turn off.
  2. Power down the speaker by turning the power & mic volume dial counter-clockwise to the OFF position. 
  3. Turn off the CH1 Volume by turning the dial counter-clockwise to the OFF position.
  4. Disinfect the headset, body pack, and speaker using a wipe located in the classroom. 
     

Need additional help?

Please fill out this webform with as much detail as possible, or contact the ET&S Help Desk team on your local campus.

Print Article